Step1 Charge the Battery

For initial use, your base unit needs to be charged for about 3 hours. Connect your base unit to your PC using the USB cable for charging.

Step2 Installing Pen Batteries

a. Remove the battery compartment cover.

b. Install two SR41 batteries, with the positive poles facing up as shown (Use the enclosed SR41 batteries).

c. Replace battery compartment cover.

WARNING:

Do not attempt to open the pen. This may cause the pen to malfunction.

Step3 Installing Ink Refill

To insert a new refill,

1. Slide the new refill into the tip of the pen.

2. Gently press the new refill until it is lodged securely in place.

To replace the ink refill,

1. Detach the cap from the digital pen.

2. Clamp the ink refill with the refill extractor. Hold the pen firmly, and apply pressure with the extractor against it.

3. Pull the used refill out.

Step4 Turn On the Base Unit

Press and hold the Power button on the base unit.

Step5 Clip your Base unit on a Paper

Your base unit can be mounted in 3 positions on top of the paper. The following images illustrate the way you can mount your base unit, according to the recommended positioning.

A. Mounting your base unit at the top center of the paper is recommended for a single paper usage:

B. Mounting your base unit at the top left corner of a paper block is recommended for right hand Users.

C. Mounting your base unit at the top right corner of a paper block is recommended for left hand Users.

Step6 Start writing

When you pick up the pen, find a position that is comfortable for you. Be careful to hold the pen in a way that does not block the signals sent from the tip of the pen to the memory unit receivers.

When you are writing with the pen, make sure its inclination to the paper surface is between 45°and 90°.

Hold the pen firmly and write normally.

Note: Make sure the pen point is 1.5cm away from the unit. Otherwise, the unit sensor may not work.